Thread Tension / Bringing Up The Bobbin Thread - Husqvarna Viking H Class E10 User Manual

THREAD TENSION / BRINGING UP THE BOBBIN THREAD

Basic thread tension setting: "4"
To increase the tension, turn the dial to the
next number up.
To reduce the tension, turn the dial to the
next number down.
Note:
The weight and irregular surface of
specialty threads, like metallics, can cause
increased tension on the thread. Reducing
the tension will prevent needle breakage.
A. Normal thread tension - upper and
bobbin thread join in fabric
B. Upper thread tension too loose - upper
thread "loops" on the underside of
fabric
C. Upper thread tension too tight - bobbin
thread "loops"on the top side of the
fabric
Note:
The bobbin thread tension does not
normally have to be adjusted.
Hold the upper thread with the left hand.
Turn the handwheel towards you until the
needle is raised. (1)
Pull on the upper thread to bring the bobbin
thread up through the stitch plate hole.
Place both threads to the back under the
presser foot. (2)
18
2