1. Rear brake pipe
2. Crankshaft position sensor/stator assembly lead
3. Wire harness
4. ISC (idle speed control) unit coupler
5. Ground lead
6. Intake air temperature sensor coupler
7. Intake air pressure sensor coupler
8. Seat lock cable
9. Fuel injector assembly
10. Radiator inlet hose
11. Starter motor lead
12. Thermostat inlet hose
13. Intake air pressure lead
14. Fuel injector lead
15. Throttle position sensor lead
16. Coolant temperature sensor lead
17. ISC (idle speed control) unit lead
18. O
sensor lead
2
19. Throttle body
A. Route the seat lock cable to the inside of the
frame.
B. Point the end of the plastic locking tie to the right,
and then cut off the excess end of the tie to 0
–
mm (0
0.20 in).
C. Fasten the wire harness at the white tape with a
plastic locking tie. Cut off the excess end of the tie
–
–
to 0
5 mm (0
0.20 in).
CABLE ROUTING (YP125R)
–
5
2-44