Yamaha 2010 XMAX YP125R Service Manual page 140

5. If the oil filter element is also to be replaced,
perform the following procedure.
M MMM M MMM M M MMM M
a. Remove the oil filter element cover "1" and oil
filter element "2".
b. Install a new O-ring "3".
TIP
Be sure to face the "
element cover in the direction shown in the illus-
tration.
c. Install the new oil filter element and the oil fil-
ter element cover.
Oil filter element cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
L LLL L LLL L L LLL L
6. If the oil strainer is also to be cleaned, per-
form the following procedure.
M MMM M MMM M M MMM M
a. Remove the oil strainer cover "1" and oil
strainer "2".
b. Install a new O-ring "3".
1
M MMM M M MMM M M MMM M
" mark "a" on the oil filter
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
2
3
New
1
c. Install the oil strainer cover.
MMM
L LLL L LLL L
7. Install:
• Engine oil drain bolt
(along with the gasket
8. Fill:
• Crankcase
a
(with the specified amount of the recom-
mended engine oil)
1
Engine oil quantity
9. Install:
• Engine oil filler cap
10.Start the engine, warm it up for several min-
utes, and then turn it off.
11.Check:
• Engine
(for engine oil leaks)
12.Check:
• Engine oil level
Refer to "CHECKING THE ENGINE OIL
LLL
LEVEL" on page 3-12.
13.Check:
• Engine oil pressure
MMM M MMM M MMM M
a. Slightly loosen the oil check bolt "1".
1
3-13
ENGINE (YP125R)
Oil strainer cover
32 Nm (3.2 m·kgf, 23 ft·lbf)
L LLL L L LLL L L LLL L
New
Engine oil drain bolt
20 Nm (2.0 m·kgf, 14 ft·lbf)
Total amount
1.60 L (1.69 US qt, 1.41 Imp.qt)
Without oil filter element replace-
ment
1.40 L (1.48 US qt, 1.23 Imp.qt)
With oil filter element replace-
ment
1.50 L (1.59 US qt, 1.32 Imp.qt)
M MMM M M MMM M M MMM M
L LLL L LLL
)
M MMM M MMM