Yamaha 2010 XMAX YP125R Service Manual page 107

1. Positive battery lead
2. Meter assembly lead
3. Self-diagnosis signal lead
4. Fuse box 1
5. Air temperature sensor lead
6. Fuse box 2
7. Starter relay lead
8. Negative battery lead
9. Headlight lead
10. Wire harness
11. Lean angle sensor lead
12. Speed sensor coupler
13. Turn signal/hazard relay lead
14. Turn signal/hazard relay
15. Battery
16. Fuse box 2 lead
17. Fuse box 1 lead
A. Route the positive battery lead under the battery
cover.
B. Route the meter assembly lead to the front of the
starter relay.
C. Route the self-diagnosis signal lead along the
negative battery lead.
D. Route the negative battery lead to the rear of the
turn signal/hazard relay lead, lean angle sensor
lead, and headlight lead.
E. Route the turn signal/hazard relay lead to the rear
of the lean angle sensor.
F. Point the end of the plastic locking tie forward, and
then cut off the excess end of the tie to 0
–
(0 0.20 in).
G. Point the end of the plastic locking tie upward, and
then cut off the excess end of the tie to 0
–
(0 0.20 in).
H. Fasten the wire harness and the other leads with a
plastic locking tie, making sure to align the tie with
the white tape on the harness.
CABLE ROUTING (YP250R)
–
5 mm
–
5 mm
2-76