Fault code No.
Item
Reinstatement method
Fault code No.
Item
Fail-safe system
Diagnostic code No.
FI diagnostic tool display
Checking method
Probable cause of malfunction
1
The vehicle has overturned.
2
Installed condition of the lean angle sen-
sor.
3
Connections
• Lean angle sensor coupler
• Wire harness ECU coupler
4
Defective lean angle sensor.
Reinstatement method
Fault code No.
Item
Fail-safe system
Diagnostic code No.
FI diagnostic tool display
Checking method
Probable cause of malfunction
24
O
sensor: no normal signal is received from the O
2
Starting the engine and operating it at idle.
30
Latch up detected.
No normal signal is received from the lean angle sensor.
Unable to start engine
Unable to drive vehicle
08
Lean angle sensor
• 0.4–1.4 (upright)
• 3.7–4.4 (overturned)
Remove the lean angle sensor and incline it more than 45 de-
grees.
• Raise the vehicle upright.
• Check the installed direction and condition of
the sensor.
• Check the coupler for any pins that may be
pulled out.
• Check the locking condition of the coupler.
• If there is a malfunction, repair it and connect
the coupler securely.
• Execute the diagnostic mode. (Code No. 08)
• Replace if defective.
Refer to "CHECKING THE LEAN ANGLE
SENSOR" on page 8-84.
Turning the main switch to "ON" (however, the engine cannot be
restarted unless the main switch is first turned "OFF").
31
O
sensor: The amount of air-fuel ratio feedback compensa-
2
tion is maintained continuously in the vicinity of the upper lim-
it.
Able to start engine
Able to drive vehicle
—
—
—
8-42
FUEL INJECTION SYSTEM
Check or maintenance job
Check or maintenance job
sensor.
2