Checking The Engine Oil Level; Changing The Engine Oil - Yamaha 2010 XMAX YP125R Service Manual

EAS37P1134

CHECKING THE ENGINE OIL LEVEL

1. Stand the vehicle on a level surface.
TIP
• Place the vehicle on the centerstand.
• Make sure the vehicle is upright.
2. Start the engine, warm it up for several min-
utes, and then turn it off.
3. Remove:
• Dipstick "1"
4. Check:
• Engine oil level
The engine oil level should be between the
minimum level mark "a" and maximum level
mark "b".
Below the minimum level mark → Add the
recommended engine oil to the proper level.
TIP
• Before checking the engine oil level, wait a few
minutes until the oil has settled.
• Do not screw the dipstick in when inspecting
the oil level.
Type
SAE 10W-30, SAE 10W-40, SAE
15W-40, SAE 20W-40 or SAE
20W-50
Recommended engine oil grade
API service SG type or higher,
JASO standard MA
0 10 30 50 70 90 110
SAE 10W-30
SAE 10W-40
SAE 10W-50
SAE 15W-40
–20 –10 0
ECA37P1044
NOTICE
Do not allow foreign materials to enter the
crankcase.
130 ˚F
SAE 20W-40
SAE 20W-50
10 20 30 40 50 ˚C
1
b
a
5. Start the engine, warm it up for several min-
utes, and then turn it off.
6. Check the engine oil level again.
TIP
Before checking the engine oil level, wait a few
minutes until the oil has settled.
7. Install:
• Dipstick
EAS37P1094

CHANGING THE ENGINE OIL

1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place a container under the engine oil drain
bolt.
3. Remove:
• Engine oil filler cap "1"
• Engine oil drain bolt "2"
(along with the gasket)
4. Drain:
• Engine oil
(completely from the crankcase)
3-12
ENGINE (YP125R)
1
2