Replacing A Usb Embedded Hypervisor Flash Device - IBM System x3850 X6 Installation And Service Manual

6. If you are instructed to return the USB flash device, follow all packaging

Replacing a USB embedded hypervisor flash device

Use this information for instructions on how to replace a USB hypervisor flash
device.
About this task
The internal USB hypervisor flash device connector is on the standard I/O book
(see "Standard I/O book" on page 32 for the location of the connector). To install a
USB hypervisor flash device, complete the following steps:
Procedure
1. Align the USB flash device with the connector on the standard I/O book board
2. Slide the lockbar up to the locked position until the lockbar is firmly seated.
3. Reinstall the standard I/O book in the server (see "Replacing the standard I/O
4. Reconnect the power cord and any cables that you removed.
5. Turn on the peripheral devices and turn on the server.
246
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide
instructions, and use any packaging materials for shipping that are supplied to
you.
and push it into the connector until it is firmly seated.
Rotate the air baffle down if rotated it up earlier.
book" on page 222).