Dsa Checkpoint Panel Test Results - IBM System x3850 X6 Installation And Service Manual

218-906-000 • 180-801-000
218-906-000 Brocade:InternalLoopbackTest Failed
Explanation: A failure was detected during the Loopback test.
Severity: Error
Serviceable: Yes
Recoverable: No
Automatically notify Support: No
User response: Complete the following steps:
1. Rerun the test.
2. Verify whether the firmware is at proper level.
3. Rerun the test.
4. If the problem remains, contact your IBM technical-support representative.
Related Links:
IBM Support Website
v
Latest level of DSA
v
Latest level of BMC/IMM
v

DSA checkpoint panel test results

The following messages are generated when you run the checkpoint panel test.
180-000-000 Check-point Panel Test Passed
Explanation: Check-point Panel Test Passed.
Severity: Event
Serviceable: No
Recoverable: No
Automatically notify Support: No
Related Links:
IBM Support Website
v
Latest level of DSA
v
Latest level of BMC/IMM
v
180-801-000 Check-point Panel Test Aborted
Explanation: Check-point Panel Test Aborted. BMC is unable to verify that the operator information panel cable is
connected.
Severity: Warning
Serviceable: Yes
Recoverable: No
Automatically notify Support: No
User response: Complete the following steps:
1. Inspect and reseat operator information panel cable at both ends.
2. Verify that the Baseboard Management Controller (BMC) is working.
3. Run the test again.
4. If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service Guide" for the
next corrective action.
318
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide