Removing A Hot-Swap Fan Assembly - IBM System x3850 X6 Installation And Service Manual

Hide thumbs Also See for System x3850 X6:

Table of Contents

power supply

Power supply

Note: Only install a spacer if one is not already installed.

b. Grasp the handle on the rear of the power supply and slide the power

supply forward into the power-supply bay until it clicks. Make sure that

the power supply connects firmly into the power-supply connector.

6. Route the power cord through the hook-and-loop strap so that it does not

accidentally become disconnected.

7. Connect the power cord for the new power supply to the power-cord

connector on the power supply.

8. Connect the other end of the power cord to a properly grounded electrical

9. Turn on the peripheral devices and the server.

10. Make sure that the ac power LED and the dc power LED on the power

supply are lit, indicating that the power supply is being supplied to the power

supply through the power cord. During normal operation, both ac and dc

power LEDs are lit. For other combinations of LEDs, see "Power-supply

LEDs" on page 165.

Removing a hot-swap fan assembly

Use this information for instructions on how to remove a hot-swap fan from the

About this task

Attention: To ensure proper server operation, replace a failed hot-swap fan

within 30 seconds.

To remove a hot-swap-fan, complete the following steps:

Note: These procedures for removing a hot-swap fan assembly apply to both the

standard I/O book and the DDR3 compute books.

1. Read the safety information and installation guidelines, see "Safety" on page vii

and "Installation guidelines" on page 45.

2. Lower the fan handle down and pull the fan-pack out of the fan bay.

3. Set the fan aside.

Chapter 6. Removing and replacing components

System x3950 x6