Replacing The 8X1.8-Inch Hot-Swap Drive Backplane Assembly - IBM System x3850 X6 Installation And Service Manual

8. If you are instructed to return the drive backplane, follow all packaging

Replacing the 8x1.8-inch hot-swap drive backplane assembly

Use this information for instructions on how to replace the 8x1.8-inch hot-swap
drive backplane assembly.
About this task
To replace the 8x1.8-inch hot-swap drive backplane assembly, complete the
following steps:
Procedure
1. Align the drive backplane assembly with the backplane slot on the storage
2. From the front of the storage book, slide the drive backplane assembly into the
3. Reconnect the cables to the backplane assembly that you disconnected earlier.
4. Reinstall the drives that you removed from the old assembly into the new drive
5. Install the drive filler panel.
6. Reinstall the storage book into the server.
7. Reconnect the power cords and any cables that you removed.
8. Turn on the peripheral devices and the server.
238
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide
instructions, and use any packaging materials for shipping that are supplied to
you.
book.
8x1.8-inch
drive filler
Drive
LEDs
8x1.8-inch
drive backplane
assembly
slot on the storage book until it is seated in place.
backplane assembly, if you have not done so (see "Replacing 2.5-inch and
1.8-inch hot-swap drives" on page 232).
Storage book