3. Reconnect the LCD display panel cable to the LCD display panel.
4. Reinstall the front operator panel
5. Reconnect the front operator panel cable to the storage book board.
6. Reinstall the storage book in the server.
7. Reconnect the power cords and any cables that you removed.
8. Turn on the peripheral devices and the server.
Removing and replacing FRUs
This topic provides information about removing and replacing FRUs.
FRUs must be replaced or installed only by trained service technicians.
The illustrations in this document might differ slightly from the hardware.
Removing a microprocessor and heat sink
This information provides instructions on how to remove a microprocessor and
heat sink.
LCD/Operator
panel
Release
latch
Chapter 6. Removing and replacing components
275