Table of Contents
Advertisement
Operations Manual
©2004 General Binding Corporation
Fig 22
Fig 23
Operating Instructions
Film Loading & Threading
The top and bottom rolls of laminating film must be of the
same width and be present simultaneously. A small amount
of adhesive will "squeeze out" during lamination. Hardened
adhesive deposits can damage the heat rollers. To avoid
any damage, select "Low-Prs Laminating" on the roller
handle, rotate the rollers at slowest speed with heat on.
Refer to the section entitled CARING FOR THE TALON
44/ 64 LAMINATOR for instructions regarding removal of
the accumulated adhesive.
Adhesive will deposit on the rollers if:
-
Only one roll is used.
-
Different widths of rolls are loaded together.
-
Either roll is loaded adhesive side against a heat
roller.
-
One or both rolls of film are allowed to run completely
off its core.
The adhesive side of the film is on the inner side of the web
(Figure 22). The shiny side of clear film must contact the
heat rollers. The dull side of the film contains the adhesive.
Use extreme caution when loading delustered (matte) film
as both sides appear dull.
Always change the top and bottom supply rolls at the same
time. Near the end of each roll of GBC laminating film is
a label stating "Warning-End of Roll". The appearance of
this label on either the top or bottom roll requires that new
rolls of film be installed as soon as the item presently being
laminated completely exits the rear of the laminator. Do not
introduce any additional items into the laminator when the
warning label is visible.
To load a roll of film; (Figure 23)
1. Lift up on the round end, left side (1), of the unwind/
rewind shaft.
2. Pull the hex end, right side (2), of the shaft out and
away from the laminator.
3. Slide the roll of film onto the film shaft ensuring adhe-
sive side is out.
4. Replace the shaft with the hex end in first then the
round end.
5. Center the roll of film.
T
44/64
ALON
CE
Page 23
Advertisement
Table of Contents
