Setting Up/Deleting Officer Data - Panasonic AG-CPD15P Operating Instructions Manual

Setting up/Deleting Officer Data

When a PC application is running,
this unit freezes in the live screen
and officer data cannot be set or
deleted.
Before using this unit, you must create
and configure officer data, such as an
officer ID and officer name. For details
on creating officer data, refer to "Text
Files Used with the Recorder" on
pages 43 - 46.
Three setup methods are available, called
the AUTO, MANUAL and LIST modes.
Check with the administrator which
mode is selected. (see "Setting Method"
on page 83)
Note:
Starting up a PC application during
officer data setup will abort the
setup operation. The recorder will
then freeze in the live screen and
disable setup and deletion of officer
data.
AUTO mode
When a USB memory device is
connected to this unit, or when
connection is detected after turning
power on, the officer data for one or
two officers is automatically read in
and activated (see "Text Files Used
with the Recorder" on pages 43 - 46).
Connect a USB memory device
containing officer data to this
unit.
The [READY] lamp flashes for
one second:
This indicates that the data was
correctly read.
The [BUSY] lamp flashes for one
second:
This indicates that the data could
not be correctly read.
Disconnect the USB memory
device and then reconnect it. If
the [READY] lamp does not flash
52
when the USB memory device
is connected again, check if the
officer data file has been correctly
saved to the USB memory device.
If the above measures do not
correct this problem, replace the
USB memory device.
Notes:
• If a USB memory device is connected
and the officer data is read during
recording, the file will be split up
at the location where reading was
effectuated.
• Once the officer data has been
read, the USB memory device
may be removed.
• Once the officer data has been
set up, it is not deleted even when
power is turned off or the mode
changed.
MANUAL mode
Display the menu on the LCD panel.
Then read and load the officer data
from the Officer setup top screen.
1. Press the [MENU] button.
The Menu appears.
2. Use the [ , ] buttons to select
[Setup/Info] and press [ ] to
confirm the entry.
3. Use the [ , ] buttons to select
[Officer] and press [
confirm the entry.
The Officer setup top screen appears.
4. Connect a USB memory device
containing officer data to this
unit.
5. Use the [ , ] buttons to select
[Officer1].
6. Use the [ , ] buttons to select
[Load] and press [ ] to confirm
the entry.
This registers officer1 and the name
and ID appear.
] to