Table of Contents
Advertisement
Setting up/Deleting Officer Data
When Front-End application is running, this unit freezes in
the live screen and officer data cannot be set or deleted.
In AUTO mode, officer data can be set using the USB
memory device.
Before using this unit, you must create and configure officer
data, such as an officer ID and officer name. For details
on creating officer data, refer to "Text Files Used with the
Recorder" on pages 29 - 33.
Three setup methods are available, called the AUTO,
MANUAL and LIST modes.
Check with the administrator which mode is selected (see
"Setting Method" on page 89).
Note:
Starting up Front-End application during officer data setup
will abort the setup operation. The recorder will then freeze
in the live screen and disable setup and deletion of officer
data.
AUTO mode
When a USB memory device is connected to the recorder,
or when connection is detected after turning power on, the
officer data for one or two officers is automatically read in
and activated (see "Text Files Used with the Recorder" on
pages 29 - 33).
Connect a USB memory device containing officer data
to the recorder.
The [BUSY] lamp flashes for one second:
This indicates that the data could not be correctly read.
Disconnect the USB memory device and then reconnect
it. If the [READY] lamp does not flash when the USB
memory device is connected again, check if the officer
data file has been correctly saved to the USB memory
device.
If the above measures do not correct this problem,
replace the USB memory device.
The [READY] lamp flashes
for one second:
This indicates that the data
was correctly read.
Notes:
•
If a USB memory device is connected and the officer data is
read during recording, the file will be split up at the location
where reading was effectuated.
•
Once the officer data has been read, the USB memory
device may be removed.
•
Once the officer data has been set up, it is not deleted
even when power is turned off or the mode changed.
36
Hide quick links:
Advertisement
Table of Contents
