Panasonic AG-CPD15P Operating Instructions Manual page 116

Error messages
No.
E00449 Unexpected update failure.
E00466
E00467
E00499
E00602 AG-RCP30 needs to be
updated!
Will start updating soon.
E00603 Unsupported Control Panel!
Replace Control Panel.
E00604 ACC Off detected !
Will power off after uploading.
Turn ACC ON to cancel
power off.
E02431 DSP error. Playback and
record cannot be performed.
E02432
E02440 System error
Couldn't format P2 cards.
E02441 Couldn't format P2 cards.
E02442 Found read only P2 cards.
Couldn't format.
E02443 Not P2 card.
Couldn't format.
E02444 No card.
Couldn't format.
E02460 System error
Couldn't delete files.
116
(continued)
Message Measure
Some other update error occurred.
• Check whether the update file for this
unit has been correctly copied to the
P2 card or USB memory device.
• Reformat the P2 card or USB memory
device before use.
• Use another USB memory device.
A connected AG-RCP30 was found to
need an update.
This unit reboots automatically to start
an update.
A Remote Control Panel not supported
by this unit was detected.
Disconnect the Remote Control Panel.
The vehicle engine switch is set to
LOCK (OFF) when "PowerOff Time" on
page 75 is set to "AUTO". The system
awaits control from a PC application to
be released.
To continue using the recorder without
turning it off, set the engine switch to ON.
Wait until the error message is cleared.
Contact your supplier if the message
does not clear after about a minute.
Insert another P2 card.
Disable P2 card write-protection.
The inserted card is not a P2 card.
Replace the card with a P2 card.
Insert a P2 card.
Contact your supplier.