Play Mode; Gpio9 For Error; Init Audio Out (Play) - Panasonic AG-CPD15P Operating Instructions Manual

Administrator Setup
GPIO9 for Rec
Enables or disables output of
recording status signals to GPIO9.
When enabled, a high level (output
voltage 5 V) indicates recording is
in progress.
Setting : ENABLE, DISABLE

GPIO9 for Error

Enables or disables output of recording
error status signals to GPIO9.
When enabled, a high level (output
voltage 5 V) and a low level (output
voltage 0 V) change at high speed to
indicate recording error status.
Setting : ENABLE, DISABLE

Init Audio Out (Play)

Use this function to set Audio Out
used when the power is on.
OFF : Audio1 and Audio2 are not
output.
1 : Audio1 is output
2 : Audio2 is output
BOTH : Both Audio1 and Audio2 are
output.
LAST : See footnote.
∗ Applies the setting in effect when power was last turned off. Unless power is
turned off properly, the operating state may not be saved correctly.
(continued)
Notes:
∗

Play Mode

Use this function to turn all valid
files starting in order from the oldest
file on two P2 cards into a virtual file
for playback.
SINGLE : Normal playback for playing
back files one at a time.
RELAY : Plays back multiple files as
one single file without the
need for further operation.
Playback pauses upon
reaching the end of the
large virtual file (the most
recently recorded file).
Playback operation is
the same as for normal
playback.
• S l o w p l a y b a c k o f a v i r t u a l
file that contains intermittent
recording files will revert to normal
playback speed at the start of a
an intermittent recording file.
Slow playback is not restored for
subsequent normal recording files.
• Quick replay starts playback 7
seconds prior to current location.
• A large virtual file consists of
multiple files and video and sound
may be momentarily interrupted in
playback between files.
77