Panasonic AG-CPD15P Operating Instructions Manual page 120

Error messages
No.
E20922 Unsupported Control Panel
Detected!
E22420 Officer's information file
cannot be loaded.
E22421 Since you are not an
administrator, you cannot
open this menu.
E22422 Officer's information file
cannot be loaded.
E22423 Admin's information file
cannot be loaded.
E22424 Officer's information cannot
be setup during record !
E22425 Cannot load Event Type.
E22426 Menu copy failure.
E22620 Auto Maintenance Canceled
E25410 GPS communication error.
Please check the GPS module.
E28201 A capacity of USB strage is
not enough to export.
E28202 Export is complete.
Restore file remained.
E28203 File not found in P2 cards.
E28400 No USB storage devices.
Couldn't start export.
E28401 Found read only P2 cards.
Couldn't start export.
120
(continued)
Message Measure
A Remote Control Panel not supported
by this unit was detected.
Disconnect the Remote Control Panel.
The officer data file (WID
corrupted. Create a new officer's data
file, save it to a USB memory device
and re-register it.
You are not registered as an administrator
and cannot open this menu. Ask a
registered administrator for assistance.
There is no Officer Registration file
or it contains the wrong data. Create
a correct Officer Registration file
(WOFFICER.TXT), copy it to a USB
memory device and reload it.
There is no Administrator Registration
file or it contains the wrong data. Create
a correct Administrator Registration
file (WADMIN.TXT), copy it to a USB
memory device and reload it.
Officer data cannot be changed during
recording. Stop recording and start over.
There is no event type file or the content
of the file is incorrect. Copy the correct
event type file (EVTYPE.TXT) to the
USB memory device and reregister it.
Connect a write-enabled USB memory
device.
Auto maintenance was not performed
because the P2 card slot cover was open
or because recording was in progress.
An error occurred in the GPS module.
Consult your supplier.
Use other USB memory device that is
not full.
Restore the file not yet restored, and
export it again.
There are no files to export. No export
operation needed.
Connect a USB memory device.
Set the P2 card write-protect switch
away from the write-protect position.
∗∗∗∗∗
.TXT) is