P2 card Insertion and Removal
(4) Close the P2 card slot cover.
Return the P2 card slot cover to its
original closed position and press
the section marked PUSH .
When you close the P2 card slot cover
after inserting a P2 card, the [READY]
lamp indicates the recorder status (see
"Indicator Lamps and Recorder Status"
on page 110).
(5) Remove the key.
18
(continued)
Removing a P2 card
(1) Open the P2 card slot cover
(see previous page).
(2) Raise the Eject button.
(3) Push the Eject button so that
the P2 card pops out.
Note:
The [BUSY] lamp blinks for a few
seconds when the P2 card slot
cover is opened. Make sure that
the blinking has stopped before
removing a P2 card.
Notes:
• If a P2 card was removed while it
was being accessed, the files may be
corrupted. Refer to "Restoring Files"
on page 71 to restore corrupted files.
• If a P2 card was removed while it
was being accessed, the P2 card
slot may be disabled. When the
recorder senses a disabled slot, it
may reboot itself automatically.
(4) Close the P2 card slot cover
(see top left of this page).
(5) Remove the key.