Panasonic AG-CPD15P Operating Instructions Manual page 35

Setup
(continued)
Items administrators can set:
Setting Item
1 Rec/Play
PowerOff Time
Init Camera
Select
Init Audio2 In
Select
PowerOn Rec
Loop Rec
Intermittent Rec
Resolution/
RecRate
∗1 Depending on the vehicle, the battery may run out of power during operation.
∗2 When recorder operation is not controlled by a PC application:
Power is turned off immediately. Note, however, that power is not turned
off while data is exported to a USB memory device, but is turned off after
completion of data export.
When recorder operation is controlled by a PC application:
Power is turned off when control from a PC application is released, or when
the PC card slot cover is opened.
∗3 Applies the setting in effect when power was last turned off. Unless power is
turned off properly, the operating state may not be saved correctly.
∗4 WMIC is the abbreviation for Wireless Microphone.
∗5 In LINK CAM mode, being linked with the change of camera, Audio2 sound
input changes. Changing to the [CAMERA1 (CAMERA2)] connector input,
sound comes from the [AUDIO IN 2 (IN CAR MIC)] connector input.
Factory Default Value Description
Recording and Playback Settings
∗
1 120 Time from the SIGNAL turn-off to recorder
shut-down (minutes)
Setting : 0, 10, 20, 30, 60, 90, 120, 180,
1 Initial video input selection (upon power on)
Setting : 1 ([CAMERA1] connector input)
INCAR Initial source selection for Audio2 input
(upon power on)
Setting : INCAR ([IN CAR MIC] connector input)
OFF Automatically start recording with power-on
OFF Loop recording
OFF Intermittent recording
Q-512k Recording resolution and bit rate
Setting : Q-512k (320x240 pixel, 512 kbps)
F-1M is 10 fps, and others are 30 fps
∗
AUTO
2
2 ([CAMERA2] connector input)
∗
LAST
3
∗
WMIC ([AUDIO IN 2] connector input)
4
∗
LINK CAM
5
∗
LAST
3
Setting : ON, OFF
Setting : OFF fixed
Setting : ON, OFF
Q-1M (320x240 pixel, 1 Mbps)
F-1M (720x480 pixel, 1 Mbps)
F-2M (720x480 pixel, 2 Mbps)
(Continued on the next page)
35