Setting And Calling Up Preset Tours - Interlogix TruVision DVR 12 User Manual

Setting and calling up preset tours

Preset tours move a PTZ dome camera to different steps (called "Keypoint" in the
interface). The camera stays at a step for a set dwell time before moving on to
the next step. The steps are defined by presets (see "Setting and calling up
presets" on page 81.)
Each preset tour consists of steps. A step consists of a step number, a dwell
time, and a speed.
The step number is the order the camera will follow while cycling through the
preset tour. The dwell time is the length of time for which a camera stays at a
step before moving to the next one. The speed is the rate at which the camera
will move from one key point to the next.
Note: The PTZ dome camera used must be able to support a preset tour
command. See Appendix F on page 143 for the complete list of PTZ commands
available by camera protocol.
To set up a preset tour:
1. From the menu toolbar, click
2. Select the preset tour number.
3. In the preset tour toolbar, click
Keypoint window appears. Select the preset number, dwell time and speed of
the step. Click OK
Note: A preset tour should have at least two presets.
4. Repeat step 3 to configure other steps in the preset tour.
5. In the preset tour toolbar, click
6. Click Back to return to live view.
TruVision DVR 12 User Manual
PTZ Settings
to add a step to the preset tour. The
to save the settings.
to call up the preset tour.
> More Settings.
83