Table of Contents
Advertisement
Configuring SNMP
SNMP is a protocol for managing devices on networks. When you enable SNMP
in the menu, network management systems can retrieve recorder status
information from the recorder via SNMP.
When you set the trap address and trap port in the recorder menu to the network
management system's IP address and port number, and set up the network
management system as trap receiver, trap notifications (such as startup) are sent
from the recorder to the network management system.
Before configuring this function, you must first install the SNMP software.
To configure SNMP protocol settings:
1. From the menu toolbar, click
2. Enter the required settings.
3. Click
Apply
to save the settings.
Configuring an FTP server to store
snapshots
You can upload your snapshots to an FTP server for storage.
Note: It is not possible to stream video to an FTP site.
To configure the FTP server settings:
1. From the menu toolbar, click
2. Check the
Enable FTP
3. Enter the FTP server information.
4. Select the desired directory. The root directory is default.
5. Click Apply.
Configuring a remote alarm host
If a remote alarm host set, the recorder sends a signal to the host when an alarm
is triggered. The remote alarm host must have the TruVision Navigator server
software installed.
To set up a remote alarm host:
1. From the menu toolbar, click
2. Enter Alarm Host IP and Alarm Host Port.
TruVision DVR 12 User Manual
Network Settings
Network Settings
box.
Network Settings
> SNMP.
> FTP.
>
More
Settings.
45
Advertisement
Table of Contents
