To configure RTSP service port:
1. From the menu toolbar, click
2. Enter the RTSP port value. The default value 554.
3. Click
Apply
to save the settings.
Telnet setup
For Technical Support only.
Checking network status
You can easily check network traffic in order to obtain information about the
recorder such as its linking status, MTU, sending/receiving rate, MAC address,
and NIC type. You can save then this information to a storage device.
You can also check the network connection status by testing its delay and packet
loss.
To check network traffic:
1. From the menu toolbar, click
Traffic window appears. The information displayed is refreshed once a
second.
To check network delay and packet loss:
1. From the menu toolbar, click
Detection.
2. Under the section "Network Delay, Packet Loss Test", enter the destination
address and click Test.
The test result appears in a pop-up window.
TruVision DVR 12 User Manual
Network Settings
>
System Settings
>
Network Settings
>
More
Settings.
Net Detect
> Traffic. The
Net Detect
>
Network
47