Fuel Pump On-Vehicle Inspection; Fuel Pump Removal; Fuel Pump Inspection; Fuel Pump Installation - Suzuki Swift User Manual

1. Fuel filler 3. Fuel return hose
2. Ignition switch 4. Fuel feed hose
1. Fuel pump 2. Filter
FUEL PUMP
ON-VEHICLE INSPECTION
WARNING:
When fuel filler cap is removed in any procedure, work must be
done with no smoking, in a well-ventilated area and away from
any open flames.
1) Remove filler cap and turn ON ignition switch.
Then fuel pump operating sound should be heard from fuel filler
for about 2 seconds and stop. Be sure to reinstall fuel filler cap
after checking.
If above check result is not satisfactory, advance to "DIAGNOS-
TIC FLOW TABLE B-2".
2) Fuel pressure should be felt at fuel return hose for 2 seconds af-
ter ignition switch ON.
If fuel pressure is not felt, advance to "DIAGNOSTIC FLOW
TABLE B-3".
REMOVAL
1) Remove fuel tank from body according to procedure described
in Section 6C and remove fuel pump from fuel tank.
2) Remove fuel pump from its bracket.
INSPECTION
Check fuel pump filter for evidence of dirt and contamination. If
present, clean and check for presence of dirt in fuel tank.
INSTALLATION
1) Install fuel pump to its bracket.
2) Install fuel pump to fuel tank and then install fuel tank to body ac-
cording to procedure described in Section 6C.
3. Fuel tank
ENGINE AND EMISSION CONTROL SYSTEM (TBI FOR G10) 6E1-11