Throttle Body Assembly; Throttle Body Installation - Suzuki Swift User Manual

6E1-14 ENGINE AND EMISSION CONTROL SYSTEM (TBI FOR G10)
1. Lower body
2. Gasket
1. Intake manifold
ASSEMBLY
1) Install injector wire and coupler to throttle body.
(a)
Use new O-ring.
Tighten injector wire coupler screw to specified torque.
Tightening Torque
(a): 2.0 N
2) Install new gasket to lower body.
3) Install upper body on gasket, using care not to cause gasket to
slip out of place.
4) Make sure to injector wire harness to fit in grooves of throttle
body and install wire cover to throttle body.
Tighten screws to specified torque.
Tightening Torque
(b): 3.5 N
5) Install fuel injector according to procedure described in FUEL
INJECTOR INSTALLATION.
6) Install TP sensor according to procedure described in
THROTTLE POSITION SENSOR INSTALLATION.
1. Wire cover
2. Fuel injector wire
3. Screws
INSTALLATION
1) Clean mating surfaces and install throttle body gasket to EFE
heater. Use new gasket.
2. EFE heater
3. Gasket
.
m (0.20 kg-m, 1.5 lb-ft)
.
m (0.35 kg-m, 2.5 lb-ft)