Fuel Pressure Inspection - Suzuki Swift User Manual

6E2-18 ENGINE AND EMISSION CONTROL SYSTEM (SFI FOR G13)
3. Fuel return pipe
Installation
1) Install new O-ring (2) to IAC valve (1).
2) Install IAC valve (1) to throttle body (3).
Tighten IAC valve screws to specified torque.
Tightening Torque
.
(a): 3.3 N m (0.33 kg-m, 2.5 lb-ft)
3) Install throttle body to intake manifold referring to "Throttle Body
Installation" section.
FUEL DELIVERY SYSTEM

FUEL PRESSURE INSPECTION

WARNING:
Be sure to perform work in a well-ventilated area and away
from any open flames, or there is a risk of a fire breaking out.
1) Relieve fuel pressure in fuel feed line referring to "Fuel Pressure
Relief Procedure" in Section 6.
2) Disconnect fuel feed hose from fuel delivery pipe.
CAUTION:
A small amount of fuel may be released when fuel hose
is disconnected. Place container under the joint with a
shop cloth so that released fuel is caught in container or
absorbed in cloth. Place that cloth in an approved con-
tainer.
3) Connect special tools and hose between fuel delivery pipe (1)
and fuel feed hose (2) as shown in figure, and clamp hoses se-
curely to ensure no leaks occur during checking.
Special Tool
(A): 09912-58441
(B): 09912-58431
(C): 09912-58490
4) Check that battery voltage is above 11 V.