Suzuki Swift User Manual page 332

ENGINE MECHANICAL (G13B, 1-CAM 16-VALVES ENGINE) 6A1-37
Check clearance by using gaging plastic.
The procedure is as follows.
1) Clean housing and camshaft journals.
2) Install camshaft to cylinder head.
3) Place a piece of gaging plastic the full width of journal of cam-
shaft (parallel to camshaft).
4) Install camshaft housing referring to "INSTALLATION" of the fol-
lowing page.
5) Tighten camshaft housing bolts in such order as indicated in fig-
ure a little at a time till they are tightened to specified torque.
Tightening Torque
.
(a): 11 N m (1.1kg-m, 8.0 lb-ft)
NOTE:
Do not rotate camshaft while gaging plastic is installed.
6) Remove housing and using scale (2) on gaging plastic (1) enve-
lope, measure gaging plastic width at its widest point.
Journal 0.040 – 0.082 mm
clearance (0.0016 – 0.0032 in.)
If measured camshaft journal clearance exceeds limit, measure
journal (housing) bore and outside diameter of camshaft journal.
Replace camshaft or cylinder head assembly whichever the dif-
ference from specification is greater.
Item
Camshaft Journal bore dia.
Camshaft journal O.D.
Standard
(0.0047 in.)
Standard
28.000 – 28.021 mm
(1.1024 – 1.1031 in.)
27.939 – 27.960 mm
(1.1000 – 1.1008 in.)
Limit
0.12 mm