Engine Control Module (Ecm) Removal; Engine Control Module (Ecm) Installation - Suzuki Swift User Manual

3) Make sure that injector wire O-ring is free from any damage and
deterioration, and apply thin coat of spindle oil or gasoline to O-
ring.
Install injector wire and tighten new wire screw to specified
torque.
Tightening Torque
(a): 3.5 N
4) Connect battery negative cable at battery.
1. Injector wire
2. Screws
5) With engine "OFF" and ignition switch "ON", check for fuel leaks.
6) Install air cleaner mounting stay as shown left.
7) Install air cleaner assembly referring to Section 6A.
1. Stay
ELECTRONIC CONTROL SYSTEM
ENGINE CONTROL MODULE (ECM)
CAUTION:
As ECM consists of precision parts, be careful not to ex-
pose it to excessive shock.
REMOVAL
1) Disconnect battery negative cable at battery.
2) Lower fuse box after removing bolt.
3) Disconnect couplers from ECM while releasing coupler lock.
4) Remove ECM from body.
INSTALLATION
1) Install ECM to body.
2) Connect couplers to ECM securely.
3) Install fuse box and tighten its bolt.
4) Connect battery negative cable at battery.
1. ECM
2. Instrument panel
3. Steering wheel
ENGINE AND EMISSION CONTROL SYSTEM (TBI FOR G10) 6E1-17
.
m (0.35 kg-m, 2.5 lb-ft)