Suzuki Swift User Manual page 290

6A-26 ENGINE MECHANICAL (G10, 1-CAM 6-VALVES ENGINE)
1. Rear mounting 5. Left mounting
2. Rear mounting No.2
bracket 6. Left mounting
3. Rear mounting No.1 7. Left mounting bracket
bracket 8. Right mounting bracket
4. Rear mounting 9. Right mounting
bracket
1. Rear mounting 6. Left mounting
2. Rear mounting No.2 7. Left mounting No.2
bracket
3. Rear mounting No.1 8. Right mounting bracket
bracket 9. Right mounting
4. Left mounting No.1 10. Torque rod bracket
bracket 11. Stiffener
5. Stopper 12. Torque rod
INSTALLATION
For M / T model
1) Lift engine with transmission into engine compartment, but do
2) Install right side engine mounting to its bracket.
3) Install left side engine mounting and its bracket.
4) Install rear mounting to body.
5) Tighten bolts and nuts of all parts installed in above steps 2),
body bracket
For A / T model
6) Remove lifting device.
7) Reverse removal procedures for installation of remainder.
8) Adjust clutch pedal free travel referring to Section 7C. (For M/T
bracket
9) Adjust gear shift control lever referring to Section 7A. (For M/T
10) Refill transmission with gear oil. (A/T fluid for A/T model) refer-
11) Refill engine with engine oil referring to Section 0B.
12) Refill cooling system referring to Section 6B.
13) Adjust A/C compressor drive belt referring to Section 0B. (if
14) Upon completion of installation, verify that there is no fuel leak-
15) Adjust accelerator cable play referring to Section 6E.
not remove lifting device.
3) and 4) to specified torque.
Tightening Torque
.
(a): 55 N m (5.5 kg-m, 40.0 lb-ft)
Tightening Torque
.
(a): 55 N m (5.5 kg-m, 40.0 lb-ft)
D Push in each drive shaft joint fully so that snap ring engages
with differential gear or center bearing support.
Use care not to damage oil seal lip when inserting.
D Clamp electric wires securely.
model)
Adjust gear select cable and oil pressure control cable referring
to Section 7B. (For A/T model)
model)
ring to Section 0B.
equipped)
age, coolant leakage, transmission oil leakage or exhaust gas
leakage at each connection.