Adding A Qos Queue - ZyXEL Communications P870HNU-51B User Manual

The following table describes the labels in this screen.
Table 61 QoS Queue Setup
LABEL
Add
No.
Active
Name
Interface
Priority
Weight
Buffer
Management
Rate Limit
Modify
Apply

15.4.1 Adding a QoS Queue

Click the Add button or the edit icon in the Queue Setup screen to configure a queue.
Figure 100 QoS Queue Setup: Add
The following table describes the labels in this screen.
Table 62 QoS Queue Setup: Add
LABEL
Enable
Name
P-870HNU-51b User's Guide
DESCRIPTION
Click this button to create a new entry.
This is the index number of this entry.
Select the check box to enable the queue.
This shows the descriptive name of this queue.
This shows the name of the Device's interface through which traffic in this queue
passes.
This shows the priority of this queue.
This shows the weight of this queue.
This shows the queue management algorithm used by the Device.
This shows the maximum transmission rate allowed for traffic on this queue.
Click the Edit icon to go to the screen where you can edit the queue.
Click the Remove icon to delete an existing queue. Note that subsequent rules
move up by one when you take this action.
Click Apply to save your changes back to the Device.
DESCRIPTION
Select this to have the Device's QoS use this queue.
Enter the descriptive name of this queue.
Chapter 15 Quality of Service (QoS)
195