ZyXEL Communications P870HNU-51B User Manual page 200

Chapter 15 Quality of Service (QoS)
Table 64 QoS Class Configuration (continued)
LABEL
MAC Mask
IP Address
IP Subnet Mask
TCP/UDP Port
Range
Exclude
Destination
MAC Address
MAC Mask
IP Address
IP Subnet Mask
TCP/UDP Port
Range
Exclude
Others
802.1P
VLAN ID
IP Protocol
IP Packet
Length
DSCP
200
DESCRIPTION
Type the mask for the specified MAC address to determine which bits a
packet's MAC address should match.
Enter "f" for each bit of the specified source MAC address that the traffic's MAC
address should match. Enter "0" for the bit(s) of the matched traffic's MAC
address, which can be of any hexadecimal character(s). For example, if you set
the MAC address to 00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a
packet with a MAC address of 00:13:49:12:34:56 matches this criteria.
Select the check box and enter the source IP address in dotted decimal
notation. A blank source IP address means any source IP address.
Enter the source subnet mask.
If you select TCP or UDP in the IP Protocol field, select the check box and
enter the port number(s) of the source.
Select this option to exclude the packets that match the specified criteria from
this classifier.
Select the check box and enter the destination MAC address of the packet.
Type the mask for the specified MAC address to determine which bits a
packet's MAC address should match.
Enter "f" for each bit of the specified source MAC address that the traffic's MAC
address should match. Enter "0" for the bit(s) of the matched traffic's MAC
address, which can be of any hexadecimal character(s). For example, if you set
the MAC address to 00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a
packet with a MAC address of 00:13:49:12:34:56 matches this criteria.
Select the check box and enter the destination IP address in dotted decimal
notation. A blank source IP address means any source IP address.
Enter the destination subnet mask.
If you select TCP or UDP in the IP Protocol field, select the check box and
enter the port number(s) of the source.
Select this option to exclude the packets that match the specified criteria from
this classifier.
This field is available only when you select 802.1Q in the Ether Type field.
Select this option and select a priority level (between 0 and 7) from the drop
down list box.
"0" is the lowest priority level and "7" is the highest.
This field is available only when you select 802.1Q in the Ether Type field.
Select this option and specify a VLAN ID number between 1 and 4095.
This field is available only when you select IP in the Ether Type field.
Select this option and select the protocol (service type) from TCP, UDP, ICMP
or IGMP. If you select User defined, enter the protocol (service type)
number.
This field is available only when you select IP in the Ether Type field.
Select this option and enter the minimum and maximum packet length (from
28 to 1500) in the fields provided.
This field is available only when you select IP in the Ether Type field.
Select this option and specify a DSCP (DiffServ Code Point) number between 0
and 63 in the field provided.
P-870HNU-51b User's Guide