The Static Route Screen - ZyXEL Communications P870HNU-51B User Manual

Chapter 13 Static Route

13.2 The Static Route Screen

Click Advanced > Static Route to open the Static Route screen.
Figure 94 Advanced > Static Route
The following table describes the labels in this screen.
Table 57 Advanced > Static Route
LABEL
#
Active
Destination
Destination /
prefix length
Netmask
Gateway
Interface
Modify
Add
Apply
186
DESCRIPTION
This is the number of an individual static route.
This field indicates whether the rule is active or not.
Clear the check box to disable the rule. Select the check box to enable it.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
If an IPv6 static route rule is specified, this parameter specifies the IPv6 network
address and prefix length of the final destination. Routing is always based on
network number.
This parameter specifies the IP network subnet mask of the final destination.
This is the IP address of the gateway. The gateway is a router or switch on the
same network segment as the device's LAN or WAN port. The gateway helps
forward packets to their destinations.
This is the interface through which the traffic is routed.
Click the Edit icon to go to the screen where you can set up a static route on the
Device.
Click the Remove icon to remove a static route from the Device. A window displays
asking you to confirm that you want to delete the route.
Click this to create a new rule.
Click this to apply your changes to the Device.
P-870HNU-51b User's Guide