ZyXEL Communications P870HNU-51B User Manual page 199

The following table describes the labels in this screen.
Table 64 QoS Class Configuration
LABEL
Class Configuration
Enable
Class Name
Classification Order
Forward to
Interface
DSCP Mark
802.1p Mark
VLAN ID Tag
To Queue
Criteria Configuration
Use the following fields to configure the criteria for traffic classification.
Basic
From Interface
Ether Type
Source
MAC Address
P-870HNU-51b User's Guide
DESCRIPTION
Select to enable or disable this classifier.
Enter a descriptive name of up to 20 printable English keyboard characters,
including spaces.
Select an existing number for where you want to put this classifier to move the
classifier to the number you selected after clicking Apply.
Select Last to put this rule in the back of the classifier list.
Select a WAN interface through which traffic of this class will be forwarded out.
If you select Unchange, the Device forward traffic of this class according to
the default routing table.
This field is available only when you select the Ether Type check box.
If you select Mark, enter a DSCP value with which the Device replaces the
DSCP field in the packets.
If you select Unchange, the Device keep the DSCP field in the packets.
Select a priority level with which the Device replaces the IEEE 802.1p priority
field in the packets.
If you select Unchange, the Device keep the 802.1p priority field in the
packets.
If you select Remark, enter a VLAN ID number (between 1 and 4095) with
which the Device replaces the VLAN ID of the frames.
If you select Remove, the Device deletes the VLAN ID of the frames before
forwarding them out.
If you select Add, the Device treat all matched traffic untagged and add a
second VLAN ID.
If you select Unchange, the Device keep the VLAN ID in the packets.
Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Select from which Ethernet port or wireless interface traffic of this class should
come.
Select a predefined application to configure a class for the matched traffic.
If you select IP, you also need to configure source or destination MAC address,
IP address, DHCP options, DSCP value or the protocol type.
If you select 8021Q, you can configure an 802.1p priority level and VLAN ID in
the Others section.
Select the check box and enter the source MAC address of the packet.
Chapter 15 Quality of Service (QoS)
199