ZyXEL Communications P870HNU-51B User Manual page 91

Note: When a layer-2 interface is in VLAN MUX Mode, you can configure up to five WAN
services on the Device.
Figure 20 Internet Connection
The following table describes the labels in this screen.
Table 17 Internet Connection
LABEL
Interface
Description
Type
Rate
Vlan8021p
VlanMuxId
ConnId
IGMP
NAT
Firewall
IPv6
P-870HNU-51b User's Guide
DESCRIPTION
This shows the name of the interface used by this connection.
A default name ipoa*, pppoa*, atm* or ptm* indicates DSL port. The ppp*
indicates a PPP connection via any one of the WAN interface.
The number after the dot (.) represents the VLAN ID number assigned to
traffic sent through this connection. The number after the underscore (_)
represents the index number of connections through the same interface.
(null) means the entry is not valid.
This is the service name of this connection.
0 and 35 or 0 and 1 are the default VPI and VCI numbers. The last number
represents the index number of connections over the same PVC or the VLAN ID
number assigned to traffic sent through this connection.
(null) means the entry is not valid.
This shows the method of encapsulation used by this connection.
This shows the maximum data rate (in Kbps) allowed for traffic sent through
this connection. This displays N/A when there is no limit on transmission rate.
This indicates the 802.1P priority level assigned to traffic sent through this
connection. This displays N/A when there is no priority level assigned.
This indicates the VLAN ID number assigned to traffic sent through this
connection. This displays N/A when there is no VLAN ID number assigned.
This shows the index number of each connection. This displays N/A when the
interface used by the connection is in Default Mode.
This shows whether IGMP (Internet Group Multicast Protocol) is activated or
not for this connection. IGMP is not available when the connection uses the
bridging service.
This shows whether NAT is activated or not for this interface. NAT is not
available when the connection uses the bridging service.
This shows whether the firewall is activated or not for this connection. The
firewall is not available when the connection uses the bridging service.
This shows whether IPv6 is activated or not for this connection. IPv6 is not
available when the connection uses the bridging service.
Chapter 5 WAN Setup
91