Monitoring and Operating the Controller
Close the Ethernet configuration window and then single click on the "Online
Configuration" button and then click on the "Start" button. The P.I.E. Tool
uploading the configuration information from the controller as shown below:
Once the upload is complete, click on the "Ethernet & Email" Group. Configure your
Ethernet and Email parameters per Section 3.27.
Once you have changed the Ethernet settings and downloaded them to your controller,
you will no longer be able to communicate with it until you change the IP address in the
®
P.I.E. Tool
to the controller's new IP Address.
You will also need to re-configure the Local Area Network (LAN) settings on your PC
back to their original settings. On some PCs and LANs, it is possible to simply allow the
PC to get these settings automatically via the DHCP server. Contact your Information
Technologies (IT) representative to see if this is available on your PC.
256
Figure 4-21 Configuration Upload in Progress
UDC3500 Universal Digital Controller Product Manual
®
should start
10/05