Honeywell UDC3500 Product Manual page 72

Configuration
Function Prompt
Lower Display
SP PROG
(optional feature)
SP Ramp must be
disabled for SP
Program prompts to
appear. If SP Rate is
enabled, it does not
operate while an SP
Program is running.
STRT SEG
END SEG
RAMPUNIT
RECYCLES
PROG END
STATE
POWER UP
KEYRESET
58
Selections or
Range of Setting
Upper Display
DISABLE
ENABLE
ENABLE2
ENABL12
1 to 20
2 to 20 even numbers
Always end in a soak
segment
(2, 4, ... 20)
TIME
EU/MIN
EU/HR
0 to 100 recycles
LASTSP (Hold at last
setpoint in the program)
F SAFE (Manual
mode/Failsafe output)
DISABLE
HOLD
ABORT
RESUME
RESTART
DISABLE
UDC3500 Universal Digital Controller Product Manual
Parameter
Definition
SETPOINT RAMP/SOAK PROGRAM—Available
only with controllers that contain this option.
SP RAMP must be disabled.
DISABLE—Disables setpoint programming.
ENABLE—Enables setpoint programming–Loop 1.
ENABLE2—Enables setpoint programming–Loop 2.
ENABL12—Enables setpoint programming–Both
Loop1 and Loop 2.
ATTENTION Detailed information for the prompts
for SP Programming may be found in Section 4.30.
The listing below is only for reference purposes.
Start Segment Number
End Segment Number
RAMPUNIT—Engineering Units for Ramp Segments
TIME in hours: minutes
RATE in Engineering units per minute
RATE in Engineering units per hour
Number of Program Recycles
Program Termination State
Program State at Program End
This configuration determines what the Program will
do in the case of a power outage during the
Program. This prompt only appears on those
instruments that have the Real Time Clock option.
ABORT—Program terminated on power up
RESUME—Continue at the same point in program
RESTART—Restart program at beginning of the
same cycle
KEY RESET—Reset/Rerun SP Program
DISABLE
10/05