Honeywell UDC3500 Product Manual page 268

Monitoring and Operating the Controller
Connecting to the Controller via Ethernet Communications
WARNING
Connecting to the Controller via Ethernet Communications requires that you change your PC's
IP settings. If you have never done this before, then it is strongly recommended that you
consult with your Information Technologies (IT) representative before proceeding.
First, write down the current IP Address, Subnet Mask and Default Gateway settings on
your PC. Put these someplace that you can find them later.
Connecting to the Ethernet Port requires that you have either an Ethernet crossover cable
or a MDI-compliant Switch or Hub available with a straight-through cable. The crossover
cable can be used to directly connect your PC to the controller while the Switch or Hub
can be used to connect your PC and Controller to the Hub or Switch via straight-through
cables.
Once you have made an Ethernet connection between your PC and the controller, then
change the Local Area Network (LAN) settings on your PC to be as follows:
IP Address:
Subnet Mask:
Default Gateway: 10.0.0.1
254
10.0.0.3
255.255.255.0
UDC3500 Universal Digital Controller Product Manual 10/05