Integrated Tray Compensator Pick Roll Assembly - IBM Infoprint 1130 Service Manual

IBM Infoprint 1130/1140
3. Remove the inner EMC shield.
4. Disconnect the compensator motor cable (A) from the system
board.
5. Place the printer on its side.
6. Locate the integrated tray compensator assembly (B) on the
bottom of the printer and disconnect the compensator arm bias
spring from the frame.
7. Remove the C-clip that rests against the right side frame from
the auto compensator pivot shaft.
8. Disconnect the compensator sensor cable (C) from the
assembly.
9. Remove the compensator assembly mounting screw (D).
10. Remove the integrated tray compensator assembly.

Integrated Tray Compensator Pick Roll Assembly

1. Remove the paper tray.
2. Place the printer on its side.
4-38
Service Manual