Table of Contents
Advertisement
IBM Infoprint 1130/1140
Service Error Codes
Service Error Codes are generally non-recoverable except in an
intermittent condition when you can POR the printer to temporarily
recover from the error condition.
Error Code
900 RIP Software
901 Engine Flash
902 General
Engine Software
903 Paperport
Link Driver Error
904 Interface
Violation by the
controller
software
905 Interface
Violation by
Paperport Device
906 Controller-
Engine Link
Driver Error
910 DC Pick
Motor DC Pick
Motor Stall
911 DC Pick
Motor Excessive
PWM
912 DC Pick
Motor below
speed
913 DC Pick
Motor over speed
2-2
Service Manual
Action
Contact the next support level or call Lexmark.
Indicates that the flash which the engine code is
programmed into is bad. Replace the system board.
These errors indicate an unrecoverable engine software
error. Replace the system board.
Check for correct location of the jumpers on the
interconnect board for the model/type printer you are
servicing. Incorrect jumper settings can cause a 902
service error. If jumpers are set correctly, replace the
system board.
Error Codes 910,911,912,913 and 914 are indications
that a Tray 1 paper feed problem has been detected. Go
to the
"Input Tray(s) Option Service Check" on
page
2-69.
Advertisement
Table of Contents
