Table of Contents
Advertisement
IBM Infoprint 1130/1140
283 Staple Jam - Check Stapler displayed.
FRU
1
Staple Cartridge Holder
2
Staple Unit
Paper feeds into finisher option output tray - Paper is not stapled -
Paper does not align with the right side.
FRU
1
Paper Alignment Wheel (if
installed)
Paper Alignment Pad
2
Paper Wheel Aligner
Assembly
Action
Check the staple cartridge holder for any
signs of damage and for any jammed
staples in the cartridge. Replace the staple
cartridge holder if damaged. If staples are
jammed in the cartridge, replace the old strip
of staples with a new strip and try the
finisher feed test from the diagnostic menu.
Remove the staple cartridge holder from the
staple unit and remove the staple unit.
Check for any staples that might be in the
staple unit mechanism. Check for correct
operation and for any signs of damage.
Action
Check to make sure the gamma wheel
aligner assembly is operating correctly and
that the wheel is touching the paper. If the
gamma wheel is not turning or touching the
paper, go to step 2. If the wheel is turning
and touching the paper, check the wheel for
any signs of wear, damage or
contamination. If any problem with the wheel
is found, replace the wheel.
Check to make sure the aligner assembly
and pads are operating correctly. Make sure
the pads are touching the paper and moving
the paper to the right side frame. If the
aligner pads are not moving into the lower
position and touching the paper, go to step
3. If the aligner pads are touching the paper,
then check the pads to make sure they are
not worn, damaged or contaminated.
Replace if necessary.
Check the paper wheel aligner assembly to
make sure it is mounted correctly. Check to
make sure there are no broken gears or
other mechanical parts. If any are found,
replace the aligner assembly. If no problem
is found, go to step 3.
Diagnostic Information
2-135
Advertisement
Table of Contents
