IBM Infoprint 1130 Service Manual page 141

IBM Infoprint 1130/1140
FRU
7 Lines spaced 49.74 mm
(1.958 inch) apart
8 Lines spaced 51.02 mm
(2.009 inch) apart
9 Lines spaced 52.23 mm
(2.056 inch) apart
10 Lines spaced 76.53 mm
(3.013 inch) apart
11 Lines spaced 95.66 mm
(3.766 inch) apart
12 Lines spaced 99.49 mm
(3.917 inch) apart
13 Lines spaced 114.79 mm
(4.519 inch) apart
Print Quality - Background
Service Tip: Some background problems can be caused by rough
papers, non-Lexmark toner cartridges or if the media texture is set to
the rough setting.
Some slick or coated papers may also cause background. Some
problems occur with printers that run a large amount of graphics in a
humid environment. The customer may try to improve the print
quality by increasing the transfer setting.
Check the charge roll to make sure it is not at the end of life.
2-114
Service Manual
Action
Replace the FRUs in the following
order:
redrive assembly
fuser assembly
Replace the transfer roll.
Replace the redrive assembly.
Replace the FRUs in the following
order:
alignment assembly
main drive gearbox assembly
Replace the FRUs in the following
order:
toner cartridge
main drive gearbox assembly
Replace the redrive assembly.
Replace the alignment assembly.