Table of Contents
Advertisement
IBM Infoprint 1130/1140
Problems with excessive static electricity buildup.
FRU
1
Front Cover Assembly
The printer does not recognize one or more output options as
installed.
Service Tip: If more than a single output option is installed, check
each one to see if the printer recognizes any single option as being
installed. If the printer recognizes any of the output options then the
base printer autoconnect system is operating correctly and the
problem is in the unrecognized option. Continue with this service
check or go to the service check for the failing output option.
FRU
1
5-Bin Mailbox Option
2
Mechanical Linkage
Assembly
2-100
Service Manual
Action
Check the front cover assembly to
make sure the ESD brush ground lead
is firmly attached to the 5-Bin Mailbox
frame. Also check to make sure the
ESD brush is not loose or damaged.
Action
Check the autoconnects, cables and
connectors of the option for any signs
of loose or damaged parts.
Remove the left and right side covers
and check the two autoconnects for
damage especially the connector pins.
Remove the output option and check
the voltages on the standard output
bin autoconnect located on the top left
rear of the printer. Go to
"Autoconnect - Top" on page
If the voltages are correct, reinstall the
output option noting the position of the
toroid on the autoconnect cable of the
lower autoconnect. Check the
voltages on each of the autoconnects.
If the toroid was moved make sure to
move it back to its original position on
the cable. If the voltages are correct,
replace the control board. If the
voltages are incorrect, replace the
failing autoconnect assembly.
5-11.
Advertisement
Table of Contents
