Table of Contents
Advertisement
IBM Infoprint 1130/1140
To run the StapleSmart Finisher Feed Test:
1. Select Finisher Tests from the menu.
2. Select Feed Tests from Finisher Tests menu.
3. The feed test runs (may take a minute for the test to complete).
4. Eight sheets of paper feed into the finisher and then staple.
Note: This test cannot be stopped until the test is completed.
5. Select Return/Stop to exit the test.
StapleSmart Finisher Sensor Test
This test can be used to verify whether or not the Finisher sensors
are working correctly.
To run the Finisher Sensor Test:
1. Select Finisher Tests from main menu.
2. Select Sensor Tests from the Finisher Tests menu.
3. There are four sensor tests that can be selected from the
Sensor Tests:
– Staple Sensors
– Cover and Door Sensor
– Pass and Media Sensor
– Bin Level Sensor
Select the test for the sensors you want to test from the menu. The
following appear on the display for each test selected.
1. Staple Sensor Test
Staple
SL=CL SP=CL H=CL
C=Cartridge Presence Sensor
SL=Staple Low Sensor
SP=Self=Priming Sensor
H=Home Signal Sensor
2. Cover and Door Sensors
Cover and Door
TC=CL SD=CL
TC=Finisher Top Cover Sensor
C=CL
Diagnostic Aids
3-27
Advertisement
Table of Contents
