Table of Contents
Advertisement
IBM Infoprint 1130/1140
To test the Bin Empty Sensor, actuate its flag in the paper output
tray. To test the Bin Full Sensor and Near Full Sensor, first actuate
the Bin Empty Sensor and then cover the Bin Full or Bin Near Full
Sensor
Note: OP=Open
Base Sensor Test
This test is used to determine if the sensors located inside the
printer are working correctly.
The following sensors can be checked:
Toner Optical Sensor
Input Sensor
Output Sensor (Fuser Exit)
Narrow Media Sensor
Front Door Sensor (Upper Front Cover)
To run the Base Sensor Test:
1. Select the Base Sensor Test.
– The operator panel displays OP for open and CL for closed.
2. Manually toggle the sensors by hand to verify that each sensor
switches from open to closed.
StapleSmart Finisher Tests
Finisher Feed Test
This test is used to verify whether or not media can be fed to a
finisher output bin and stapled. No information is printed on the test
pages as the printhead is not turned on. Eight sheets of paper feed
and then the pages staple.
Note: This test can be run using any of the paper sizes supported
by the printer.
The media is fed from the selected source and then outputted to the
finisher output bin.
3-26
Service Manual
CL=Closed
Advertisement
Table of Contents
