Table of Contents
Advertisement
IBM Infoprint 1130/1140
Tray X Empty message displays. Tray does not respond to loading
paper. No response from the front door switch.
FRU
1
High Capacity Feeder
Option Control Board
2
Elevator Top Optical
Sensor Cable
Elevator Top Optical
Sensor
Tray X Paper Low Message displays when the high capacity feeder
input tray is full or has adequate paper in the tray.
FRU
1
Paper Low Switch
Paper Low Switch Cable
High Capacity Feeder
Option Control Board
Action
Check the voltage on the board at
J4-2 (green). The voltage measures
approximately +5 V dc. If incorrect,
disconnect the cable at J4 and check
the voltage again. If incorrect,
replace the high capacity feeder
option control board.
Check the continuity of the sensor
cable. If incorrect, replace the cable.
If correct, replace the top optical
sensor assembly.
Action
Run the sensor diagnostics for tray X
(X=the number that represents the
high capacity input tray). If the test
fails, check the voltage at J3-1
(gray). The voltage measures
approximately +24 V dc. If incorrect,
disconnect the paper low switch
cable from J3 and measure the
voltage again on J3-1. If incorrect,
replace the high capacity feeder
option control board. If correct,
check the cable for a short between
pins 1 and 2 on the cable. If
incorrect, replace the cable. If
correct, check the switch for a bent
or deformed actuator lever or
defective switch. If incorrect, replace
the switch.
Diagnostic Information
2-83
Advertisement
Table of Contents
