Table of Contents
Advertisement
IBM Infoprint 1130/1140
Misalignment of sheets to be stapled.
FRU
1
Left Side Bail Assembly
2
Stapler Gearbox Assembly
Sheets are transported into output tray but not stapled.
FRU
1
Sol 1, Stapler Drive
Stapler Assembly
Stapler Card Assembly
Stapled Sheets are not transported to the output tray.
FRU
1
Sol 2 (Stapler Gearbox
Assembly)
Stapler Card Assembly
POST incomplete - Stapler cycles several times
FRU
1
Stapler Assembly
Action
Check the left side bail assembly for any
signs of binding, missing, or broken parts.
Check the stapler gearbox assembly for
correct operation.
Action
Disconnect Sol 1 cable from J5 on the
stapler card and measure the resistance of
the solenoid across the cable connector. It
should measure approximately 48 ohms
(when cold). If incorrect, replace the Stapler
Gearbox assembly. If correct, replace the
stapler card assembly.
Action
Disconnect Sol 2 cable from J8 on the
stapler card and measure the resistance of
the solenoid across the cable connector. It
should measure approximately 48 ohms
(cold). If incorrect, replace the stapler
gearbox assembly. If correct, replace the
stapler card assembly.
Action
Replace the stapler assembly.
Note: When replacing the stapler assembly,
observe the location of the ground lead from
the stapler assembly and the finisher frame,
and make sure the ground lead is correctly
reattached.
(Flag or spring off stapler unit)
Will also happen when pin 7 of J3 open.
Diagnostic Information
2-137
Advertisement
Table of Contents
