Table of Contents
Advertisement
IBM Infoprint 1130/1140
Smart Cartridge Contact Assembly Service Check
Note: If you are unable to clear a "32-Unsupported Cartridge" User
Error Message, make sure a Lexmark T print cartridge is correctly
installed in the printer. The cartridge is easily identified by the
contact board located on the right side rear of the cartridge. Install
another print cartridge before attempting to troubleshoot the printer.
Check to make sure the smart contact assembly cable is properly
connected to J20 on the
any signs of damage or improper installation of the smart chip. Also
check to make sure there is proper contact between the smart chip
on the cartridge and the smart cartridge contact assembly.
Service Tip: An intermittent "32-Unsupported Cartridge" User Error
Message can be caused by poor contact between the smart
cartridge contacts in the printer and the smart chip. Also check for
proper seating of the smart cartridge cable to the system board.
FRU
1
Smart Cartridge Contact
Assembly
System Board
board. Check the print cartridge for
system
Action
Check the voltage on the smart
cartridge contact. The voltage
measures approximately +3.8 V dc
when not writing data to the system
board. If data is being written, the
voltage measures approximately
0 V dc. If incorrect, disconnect the
cable from J20 on the system board
and check the voltage on J20-1. The
voltage measures approximately
+5 V dc. If incorrect, replace the
system board. If correct, replace the
smart cartridge contact assembly.
Diagnostic Information
2-121
Advertisement
Table of Contents
