Blodgett DFG-100 XCEL Installation And Operation Manual page 37

MANAGER LEVEL PROGRAMMING
Entering the programming mode
1. Press the PROG KEY (10). The top display
reads CodE.
2. Use the product keys to enter the program-
ming access code: 4 5 1 2. Press the ENTER
KEY (14). The top display reads SYS.
Programming hold
Hold allows product to be kept warm in the oven
at a programmed time and temperature.
1. Press the SCAN KEY (15). The top display
reads Hold. Press the TOGGLE/CLEAR KEY
(11) to toggle between YES and no. Press the
SCAN KEY (15).
If no is chosen:
a.. Press the SCAN KEY (15) to advance to pro-
gramming the setback mode.
If yes is chosen:
a.. The top display reads HOLD. The bottom
display gives the current hold time. Press
the TOGGLE/CLEAR KEY (11). Use the
product keys to enter a hold time from 0
to 9 hours. Press the SCAN KEY (15) to
enter the new hold time (HR:MN).
b.. The top display reads HOLD. The bottom
display gives the current hold tempera-
ture. Press the TOGGLE/CLEAR KEY (11).
Use the product keys to enter a hold tem-
perature from 140_F---210_F. Press the
SCAN KEY (15) to enter the new hold tem-
perature.
c.. The top display reads FAn. The bottom
display gives the current fan mode. To
change the fan mode press the TOGGLE/
CLEAR KEY (11). The bottom display
toggles between Hi and Lo. Press the
SCAN KEY (15) to enter the new fan mode
and continue with programming the set-
back mode.
Programming the setback mode
The setback mode operates as a power saving fea-
ture. After a period of non-use (the setback time) the
oven temperature automatically decreases to the
setback temperature. The oven will maintain this
temperature until a product key is pressed.
1. The top display reads SEtb. The bottom dis-
play gives the setback mode. To change the
setback press the TOGGLE/CLEAR KEY (11).
The bottom display toggles between YES and
no. Press the SCAN KEY (15).
If no is chosen:
a.. The controller advances to programming
the temperature mode.
If yes is chosen:
a.. The bottom display gives the current set-
back time. Press the TOGGLE/CLEAR KEY
(11). Use the product keys to the enter the
desired setback time. Press the SCAN KEY
(15) to enter the new setback time.
NOTE: The minimum setback time is 20:00.
The maximum setback time is 59:59.
b.. The bottom display gives the current set-
back temperature. Press the TOGGLE/
CLEAR KEY (11). Use the product keys to
the enter a setback temperature from
140_F---300_F. Press the SCAN KEY (15) to
enter the new setback and continue with
programming the temperature mode.
33
Operation
Blodgett IQ2T Control