Blodgett DFG-100 XCEL Installation And Operation Manual page 31

20. RATE SWITCH --- switches oven between
standard rate (60,000 BTU) and high rate
(80,000 BTU) while in high fan.
NOTE: High rate is disabled with low fan.
21. GAS ON/OFF SWITCH --- press to shut off gas
to the oven.
OVEN OPERATION
Oven Startup:
1. Toggle the POWER SWITCH (1) to ON. The
oven preheats to the lowest programmed first
stage temperature. The LEDS (16) for all prod-
ucts with the same first stage temperature light.
While the unit preheats the TOP DISPLAY (2)
gives the actual temperature. The BOTTOM
DISPLAY (4) reads Lo if the oven is more than
10_ below setpoint. When the oven reaches
¦10_ of the preheat temperature an alarm
sounds and the bottom display reads LoAd.
Single Product Cooking Procedure:
NOTE: If the led next to the desired product key is
lit skip step 1.
1. Press the desired PRODUCT KEY (17). The
oven preheats to the first stage temperature for
the selected product. When the oven reaches
¦10_ of the preheat temperature an alarm
sounds and the bottom display reads LoAd.
NOTE: If high fan is chosen, high rate may be
selected
SWITCH (20).
2. Load the product into the oven. Press the de-
sired PRODUCT KEY (17). If the shelf timing
function is toggled on for that product key, the
top display will read SHLF. Press a SHELF KEY
(18) to assign the product to that shelf and
start the cook cycle. If the shelf timing function
is toggled off for that product key, pressing the
product key will start the cook cycle. The TOP
DISPLAY (2) reads --- --- --- ---. The BOTTOM
by toggling the RATE
DISPLAY (4) counts down the cook time in
minutes: seconds.
NOTE: If the selected product has a cook time
of greater than 59:59 the top display
reads Hr --- --- for the total number of
hours. The bottom display counts down
the cook time in minutes:seconds.
NOTE: If the selected product is a single stage
recipe the LEDS for all single stage
products with the same cook tempera-
ture and fan speed will light. If the se-
lected product is a multiple stage rec-
ipe no other product LEDS will light.
NOTE: Press and hold the selected product
key for three seconds to cancel the
cook cycle for normal operation. To
cancel the bake cycle when using
shelf timing, press and hold the
SHELF KEY (18) for 3 seconds or
press TOGGLE/CLEAR (11) and the
corresponding shelf key.
3. When the cook time expires an alarm sounds
and the top display reads donE.
4. Press the selected product key to silence the
alarm. Remove the product. If shelf timing is
used, press the flashing SHELF KEY (18) to si-
lence the alarm.
5. The led for the product with the least time re-
maining flashes faster than the led for the oth-
er product. The TOP DISPLAY (2) reads
--- --- --- ---. The BOTTOM DISPLAY (4) counts
down the cook time for the product with the
least time remaining.
NOTE: To view the remaining cook time for
the other product press and hold the
SCAN KEY (15). The bottom display
cycles through the remaining cook
times for each product. Only the led
for the product with the cook time dis-
played will be lit.
27
Operation
Blodgett IQ2T Control