Assign Zone Voice Descriptors - ADEMCO Lynx Installation Instructions Manual

Use this mode to assign voice descriptors for each zone. These are the descriptors that are announced when the
system announces any event involving a zone number. Each descriptor can consist of up to 3 words. Press *84 while
in Programming mode.
The prompts for *84 are as follows:
84
A 01
b
C
Cd
The following explains these prompts in detail. The left two columns identify the prompts and list the available
entries. The right-most column provides a further explanation of the entries.
NOTE: Entry of a number other than one specified will give unpredictable results.

Assign zone voice descriptors

84
0 = exit mode
1 = enter mode
Zone number
A
zz
[*] = continue to next prompt (any existing
descriptors will be announced, then descriptor
1 will be repeated)
00 = exit voice descriptor mode
Descriptor 1
b
Enter [#] + 2-digit vocabulary index number of
vv
first descriptor word for this zone.
6 = accept word and advance to descriptor 2
(descriptor 2 will be announced)
8 = accept word and advance to next zone
(prompt A....zz)
Press any other key to repeat the selected
word.
Descriptor 2
C
vv
Enter [#] + 2-digit vocabulary index number of
second descriptor word for this zone.
6 = accept word and advance to descriptor 3
(descriptor 3 will be announced)
8 = accept word and advance to next zone
(prompt A....zz)
Press any other key to repeat the selected
word.
Descriptor 3
d
vv
Enter [#] + 2-digit vocabulary index number of
third descriptor word for this zone.
6 or 8 = accept word and advance to next zone
(prompt A....zz); zone descriptor will be
announced
Press any other key to repeat the selected
word.
*84 Assign Zone Voice Descriptors
Voice Descriptors --------------------- Main Menu prompt
Zone Number -------------------------- for entering the zone number to be programmed
Descriptor 1 ---------------------------- for assigning the first word of this zone's descriptor
Descriptor 2 ---------------------------- for assigning the second word of this zone's descriptor
Descriptor 3 ---------------------------- for assigning the third word of this zone's descriptor
Pressing 1 advances to the next prompt below.
Pressing 0 exits mode, upon which this prompt blinks, indicating the mode
is inactive. Press [*] + any field number to go to that field.
Enter the 2-digit zone number for which this descriptor is being assigned,
then press [*].
Enter the first word of the descriptor for the selected zone.
Enter the second word of the descriptor for the selected zone.
Enter the last word of the descriptor for the selected zone.
–29–