Remote Programming/Control (Downloading) - ADEMCO Lynx Installation Instructions Manual

Remote Programming/Control (Downloading)

General Information
The LYNX can be remotely programmed from an IBM-compatible Personal Computer (PC), a HAYES Modem, and
ADEMCO's V-LINK® Software (as specified below).
U L
Multiple levels of security protect remote programming of the control against compromise by someone attempting to
defeat the system.
1. Security Code Handshake: An 8-digit download ID code must be matched between the Control and the
downloader .
2. Site-Initiated Remote Programming: The installer or subscriber initiates the callback from the subscriber
premises (by entering Installer Code + # + 1) while disarmed. All parameters can then be downloaded via the
phone lines using a personal computer.
3. Station-Initiated Remote Programming: The operator calls the site from your office to initiate the download
call. The Control hangs up and then calls back the PC via the preprogrammed telephone number. The unit can
then be uploaded, downloaded, or controlled from your office.
4. Telco Handoff: Allows the installer or subscriber to perform a download session on the call initiated from the
site or from local laptop computer.
5. Data Encryption: Data passed between the PC and the Control is encrypted for security so that it is very
difficult for a foreign device tapped into the phone line to take over communication and substitute system-
compromising information.
Equipment required to download to a LYNX at the premises
• An IBM PC compatible computer and appropriate interconnecting cables.
• Either a HAYES brand SMARTMODEM 1200 (Level 1.2 or higher external or Level 1.1 or higher [with 4
position DIP switch] internal style), or a HAYES brand Optima 24 Plus FAX96 Modem.
• V-LINK® Downloading Software Diskette (at revision level supporting the LYNX).
Initial Download: Enter Installer Code + # + 5. This sets field * 95 to 4 rings, and system to "no call-back" option.
The download computer can then call the subscriber, make connection, and download all programming data.
Flexible Callback: If enabled in field *93, the download operator can temporarily change the last 1, 2, or 3 digits
(depending on selection) of the call back number. This allows the control to call back a computer other than the one
programmed, which may be helpful at times of high computer traffic.
Remote Programming Information
The downloading system can perform many functions when in communication with the Control. Besides uploading
and downloading, the status of the system can be observed and various commands can be initiated, as follows:
• Arm the system in the away mode; disarm the system.
• Bypass a zone.
• Force the system to accept a new program download.
• Shut down communication (dialer) functions (for nonpayment of monitoring fees in an owned system).
• Shut down all security system functions (for nonpayment for a leased system).
• Inhibit local keypad programming (prevents account takeover).
• Command the system to upload a copy of its resident program to the office.
• Set the time
• Read: arming status, AC power status, lists of faulted zones, bypassed zones, zones currently in alarm, zones
currently in trouble, and rf sensors with low battery conditions; read control's time.
Notes: After the control and the PC have established valid communication, the keypad will become inactive and
will display "CC." The keypad will become active after the download communication is terminated. The detailed
operation of the download functions is covered in the installation instructions for the V-LINK® Downloading
Software Diskette.
Remote Programming Advisory Notes
• Keypad entries are ignored during the time interval stated above.
• A copy of the program downloaded may printed using the IBM PC-compatible computer's internal report
generator, when an optional printer is connected (consult your PC manual for proper printer and connections).
• Program upload or download time is approximately one minute, fifteen seconds for a complete program.
Downloading may only be performed if a technician is at the site.
–31–